Atomizer Cleaning

Cleaning the atomizer regularly will increase longevity and increase satisfaction. Follow the instructions below for weekly cleaning..  

1: Hold a paper towel at the cartridge end of the atomizer and blow through the battery end, until no liquid is expelled. 

2: Place your atomizer in the bottom of a small plastic cup or tumbler and fill with Crest Pro Health: Blue mouthwash.

3: Soak for 15-30 minutes, occasionally agitating the tumbler gently.  

4: Take out the atomizer, rinse with warm water and blow out the remaining liquid.

5: Take a hair dryer and lightly dry the atomizer. If you do not have a hair dryer then place a paper towel on the counter and place the atomizer (cartridge side down) on the paper towel overnight.

6: In the morning, make sure your atomizer is completely dry (a wet atomizer will not work). Attach a fresh battery and take a few puffs without the cartridge attached. If it is completely dry and free of debris the atomizer will heat up without producing vapor. Also, this will get rid of any excess moisture.

7: Prime your atomizer by placing 3 drops of E-liquid on the wire mesh itself and 4 or 6 drops on the side of the bowl. Place it on the paper towel for a few minutes (cartridge side up) to allow the liquid to drain into the bowl..

8: Make sure you have a fresh battery and a topped off cartridge. Put your MaxxVapor Pro together and start vaping. It may take a few minutes but you should experience an easier draw and better vapor. You may still taste the minty freshness of the mouthwash but it should not last long.